Paul Yaffe Bagger Nation 10" Handlebars Black Apes Harley Road King Road Glide 1".
The label identifies this as Drag Specialties Distributor Part Number 0601-1944 (Manufacturing Part Number PYO50300810). [1]
These are Paul Yaffe Originals Bagger Apes (Classic Bagger Apes). The label note "1X10 BLACK BN" specifies they have a 1-inch diameter and a 10-inch rise (height) in a gloss black finish. [1, 2]
Throttle-By-Wire (TBW) notches cut into the right-hand handlebar tip, having electronic throttle compatibility. [1, 2]
Exact Model & Year Fitment:
These handlebars are specifically designed for the following Harley-Davidson Touring (Bagger) models: [1]
Note on Year Restrictions: These bars feature a narrower center section clamping area (7.25 inches) that sits perfectly inside the nacelle/clamp setups of older Road Kings and Road Glides. They will not fit 2014-newer Road Glides (which switched to a 1.25-inch riser clamp) or models with standard Batwing Fairings (such as the Street Glide or Electra Glide), because those require a much wider center base to reach out around the fairing's inner gauges. [1, 2]
Crucial Installation Prerequisites
Because these handlebars span across eras that changed from mechanical throttle cables to digital sensors, keep these fitment details in mind:
- For 2008 to 2013 Models: These models utilize factory Throttle-by-Wire. The notches on the right side of your bar will slip straight into your digital twist-grip sensor (TGS) assembly. [1, 2]
- For 1994 to 2007 Models (Cable Throttle): Because these older bikes use traditional dual throttle cables rather than digital sensors, you cannot leave the notched end open. You must install a Handlebar Plug (such as Drag Specialties Part #0634-0331 or 598244) to fill the slots so your throttle sleeve twists smoothly. [1, 2]
- Riser Clamp Requirement: If you are putting these on a 2007 or older bike, Paul Yaffe states that you must upgrade to the updated Harley one-piece top handlebar riser clamp (OEM #55918-08 or Drag Part #0603-0363) to prevent the tall bars from twisting or slipping. [1]
- Control Space: The bars are fully knurled, dimpled, and pre-drilled so you can run all of your switch housing wiring completely internally through the tubes for a clean look. [1, 2]
Selling as pictured, save on shipping by coming to store in Butler, Pa.
Â
102626
Â
Â
Â